alan@dev:~$ ssh [email protected]
pi@raspberrypi:~ $ ls /sys/bus/sdio/devices/ 
mmc1:0001:1  mmc1:0001:2
pi@raspberrypi:~ $ sudo ./sx-sdmah/load_driver.sh 
Morse_cli Version: rel_1_10_2_2023_Nov_22
FW Version: rel_1_10_2_2023_Nov_22
pi@raspberrypi:~/sx-sdmah $ cat ~/sx-sdmah/conf/US/sta_halow_sae.conf
ctrl_interface=/var/run/wpa_supplicant_s1g
network={
    ssid="silex-ap"
    key_mgmt=SAE
    sae_password="xxxxxxxx"
    ieee80211w=2
}
p2p_disabled=1
ignore_old_scan_res=1
pi@raspberrypi:~/sx-sdmah $ sudo wpa_supplicant_s1g -i wlan0 -c ~/sx-sdmah/conf/US/sta_halow_sae.conf -B
Successfully initialized wpa_supplicant
morse: disable long sleep on ifname wlan0
	Long Sleep Mode: disabled
pi@raspberrypi:~ $ ifconfig 
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.0.10  netmask 255.255.255.0  broadcast 192.168.0.255
        inet6 fe80::db7b:df64:fe44:f2ed  prefixlen 64  scopeid 0x20<link>
        ether 2c:cf:67:7c:a7:a2  txqueuelen 1000  (Ethernet)
        RX packets 333  bytes 39241 (38.3 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 303  bytes 47585 (46.4 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 25  bytes 2839 (2.7 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 25  bytes 2839 (2.7 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
wlan0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 192.168.200.2  netmask 255.255.255.0  broadcast 192.168.200.255
        ether 1c:bc:ec:2f:84:bc  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
How to scan the wireless:
pi@raspberrypi:~ $ sudo iw dev wlan0 scan | grep -A10 silex
	SSID: silex-ap
	Supported rates: 1.0 2.0 5.5 6.0* 11.0 12.0* 18.0 24.0* 
	Country: US	Environment: bogus
		Extension ID: 201 Regulatory Class: 68 Coverage class: 0 (up to 0m)
		Channels [3 - 3] @ 30 dBm
	RSN:	 * Version: 1
		 * Group cipher: CCMP
		 * Pairwise ciphers: CCMP
		 * Authentication suites: SAE
		 * Capabilities: 16-PTKSA-RC 1-GTKSA-RC MFP-required MFP-capable (0x00cc)
	Supported operating classes:
pi@raspberrypi:~/sx-sdmah $ sudo ip addr flush dev wlan0 && sudo ip addr add 10.0.0.1/24 brd 10.0.0.255 dev wlan0 && sudo ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
    link/ether 2c:cf:67:7c:a7:a2 brd ff:ff:ff:ff:ff:ff
    inet 192.168.0.10/24 brd 192.168.0.255 scope global noprefixroute eth0
       valid_lft forever preferred_lft forever
    inet6 fe80::db7b:df64:fe44:f2ed/64 scope link 
       valid_lft forever preferred_lft forever
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
    link/ether 1c:bc:ec:2f:84:bc brd ff:ff:ff:ff:ff:ff
    inet 10.0.0.2/24 brd 10.0.0.255 scope global wlan0
       valid_lft forever preferred_lft forever
pi@raspberrypi:~ $ ping 10.0.0.1
PING 10.0.0.1 (10.0.0.1) 56(84) bytes of data.
64 bytes from 10.0.0.1: icmp_seq=1 ttl=64 time=4.99 ms
64 bytes from 10.0.0.1: icmp_seq=2 ttl=64 time=4.97 ms
64 bytes from 10.0.0.1: icmp_seq=3 ttl=64 time=4.96 ms
64 bytes from 10.0.0.1: icmp_seq=4 ttl=64 time=5.24 ms
64 bytes from 10.0.0.1: icmp_seq=5 ttl=64 time=5.14 ms
64 bytes from 10.0.0.1: icmp_seq=6 ttl=64 time=7.79 ms
64 bytes from 10.0.0.1: icmp_seq=7 ttl=64 time=4.73 ms
64 bytes from 10.0.0.1: icmp_seq=8 ttl=64 time=4.73 ms
64 bytes from 10.0.0.1: icmp_seq=9 ttl=64 time=5.11 ms
64 bytes from 10.0.0.1: icmp_seq=10 ttl=64 time=4.84 ms
64 bytes from 10.0.0.1: icmp_seq=11 ttl=64 time=4.66 ms
64 bytes from 10.0.0.1: icmp_seq=12 ttl=64 time=4.91 ms
64 bytes from 10.0.0.1: icmp_seq=13 ttl=64 time=5.31 ms
64 bytes from 10.0.0.1: icmp_seq=14 ttl=64 time=28.5 ms
64 bytes from 10.0.0.1: icmp_seq=15 ttl=64 time=4.99 ms
^C
--- 10.0.0.1 ping statistics ---
15 packets transmitted, 15 received, 0% packet loss, time 14021ms
rtt min/avg/max/mdev = 4.660/6.721/28.453/5.853 ms
Access Point Silex AP-150-AH configuration:
900MHz AP:
Wireless LAN
------------
Channel (MHz): 903.5
Channel Bandwidth: 1MHz
SSID: silex-ap
Network Authentication: WPA3-Personal
Security Configuration
Pre-Shared Key: pastelito
Extension Configuration
-----------------------
Beacon Interval(ms): 100
DTIM Period: 10
Transfer Rate: AUTO
Tx Power(%): 100
Weak RSSI threshold(dBm): -75